HD 760 (serv.man4) - Harman Kardon Audio User Guide / Operation Manual. Page 18

Programmed Recording

16

The tracks can be entered with the front
panel buttons too by selecting the favorized
track with the 

buttons 

8

and

confirming with the 

buttons 

!

d

.

6. As each track number is programmed,
the main portion of the display will flash
several times between the track number
and the amount of time remaining on the
cassette.

7. When the "A" side of the cassette is full
or you have programmed all tracks to be
recorded on that side, press the 

button 

^ r

to change to B-side

programming. Note that the dot is under
the "B" in the A–B icon in the upper right
corner of the Information Display.

8. Follow the instructions in Steps 5 above
to program the CD tracks you wish to have
recorded on the B side of the cassette.

9. When you have completed all program-
ming, put your cassette deck in the record
mode, and then press the 

button 

4

j

on the HD760. The HD760 will provide

four seconds of blank leader, and then play
all tracks programmed for the A side of the
cassette.

10. When all tracks for the A side have
been played, the HD760 will go into pause,
allowing you to change sides on the
cassette. Turn the cassette over, and place
the tape deck in the record mode again.

11. When the recording is running, press
the 

button 

4 j

on the HD760

again, and it will play all tracks that have
been programmed for the B side of the
tape.

IMPORTANT NOTE: If the 

›

sign

appears in the right lower corner of the
Information Display during programming,
it means that the total time of the selected
tracks is greater than the length of the
cassette. Each time the button

5

or 

e

is pressed

the latest programmed track is deleted to
reduce the total running time.

NOTE: This Programmed Recording
shouldn't be used with the"CD Sync"
function of HK Cassette decks for starting
and stoping the CDP and deck syn-
chroniously.

No lights on Front Panel

Remote does not appear 
to operate 

Front panel lights, but CD 
does not play

Play indicator lights, but 
no sound is heard

Sound skips or stutters 
during play

Sound is continually distorted

• No AC power

• Main Power Switch turned off
• Weak batteries
• Blocked sensor

• Disc upside down

• Poor connections

• Wrong source connected

• Disc may be damaged
• Surface vibrations

• Incorrect input

• Make certain AC power cord is plugged into 

a live outlet.

• Turn on Main Power Switch. 
• Install fresh batteries, observing polarity indications.
• Remove obstructions from the front panel sensor or

connect a remote sensor to the 

jack

on the rear panel. 

• Reload disc with label side facing up.

• Make certain connections are secure and made

to the correct (e.g., 

) input.

• Select CD source on receiver or preamp.

• Try another disc.
• Isolate the unit from vibration by placing it on a

firm surface or move it further away from speakers.

• Make certain that the HD760 is connected to a line-

level audio input, NOT a digital audio or phono input.

Troubleshooting