Read Harman Kardon GO PLAY MICRO (serv.man2) EMC - CB Certificate online
Page 6 of 58
Report No. 15039146 001
TRF No. IEC60950_1B
Manufacturer’s Declaration per sub-clause 6.2.5 of IECEE 02:
The application for obtaining a CB Test Certificate
includes more than one factory location and a
declaration from the Manufacturer stating that the
sample(s) submitted for evaluation is (are)
representative of the products from each factory has
been provided.................................................................:
includes more than one factory location and a
declaration from the Manufacturer stating that the
sample(s) submitted for evaluation is (are)
representative of the products from each factory has
been provided.................................................................:
Yes
Not applicable
When differences exist; they shall be identified in the General product information section.
Name and address of factory (ies) .......................... : Guoguang Electric Company., Limited. (GGEC)
No 8 Jinghu Road, Xinhua Street, Huadu Reg,
Guangzhou, Guangdong 510800, P. R. China
Guangzhou, Guangdong 510800, P. R. China
General product information:
The EUT is a computer stereo system speaker for the use within the scope of IEC/EN 60950-1.
The EUT is supplied power from DC input jack by a switching power supply adapter which was compliance
with sub-clause 2.5 as Limited Power Source. It can also be powered by 8 C size batteries.
with sub-clause 2.5 as Limited Power Source. It can also be powered by 8 C size batteries.
The switching power supply adapters were tested and approved by Intertek ETL SEMKO (for details see
Table 1.5.1), adapter was not evaluated as a part in this report and a sample of the equipment was
subjected to a construction check and accepted during this approval.
Table 1.5.1), adapter was not evaluated as a part in this report and a sample of the equipment was
subjected to a construction check and accepted during this approval.
The test samples are engineering samples without serial number.
Engineering Considerations
•
The product was submitted and tested for use at the maximum ambient temperature (Tma)
permitted by the manufacturer’s specification of: 25°C
permitted by the manufacturer’s specification of: 25°C
•
The means of connection to the mains supply is not directly connected to the mains
MARKINGS AND INSTRUCTIONS
The product also marked with:
•
(IEC 60417-5009) for the stand-by condition. (See subclause 1.7.8.3)
Abbreviations used in the report:
- normal conditions
N.C.
- single fault conditions
S.F.C
- functional insulation
OP
- basic insulation
BI
- double insulation
DI
- supplementary insulation
SI
- between parts of opposite
polarity
polarity
BOP
- reinforced insulation
RI
- short-circuit S-C - equipment under test
EUT
Indicate used abbreviations (if any)
Click on the first or last page to see other GO PLAY MICRO (serv.man2) service manuals if exist.