AVR 10 (serv.man7) - Harman Kardon Audio User Guide / Operation Manual. Page 18

16

ENGLISH

This unit is designed for trouble-free operation. Most problems users encounter are due to operating errors. So, if you have a problem, first check this list for a possible
solution. If the problem persists, consult your authorized Harman Kardon Service Center.

No lights illuminate when POWER button is pressed

1. Unit is plugged into a live outlet

No sound is heard

1. Correct input function selector button has been pressed
2. Volume is turned up
3. Speakers are connected properly
4. TAPE MON is not selected
5. Selected source is playing and functioning properly

Dolby Surround does not work on center and rear channels

1. Correct surround mode is selected
2. Rear and Center levels are turned up
3. Selected source is providing Dolby encoded signal
4. Software is encoded with Dolby Pro Logic signal

Selecting video component produces sound but no picture

1. Video cables are connected properly
2. Appropirate input or channel is selected on TV
3. Video/Antenna Switch on TV is set to Video

The TV picture does not match the sound

1. Video sources are properly connected to receiver
2. Video/Antenna Switch on TV is set to Video

No output from one or more channels

1. Cables are not defective: Check/replace speaker cables
2. The signal source is operating and providing proper signal output to the AVR10.

No center channel output

1. Dolby surround or 3-Stereo is turned on
2. Phantom mode is not active

Tuner sound has a large amount of interference, or

1. The antenna is properly connected

The “Stereo” display is not illuminated, or

2. The antenna is properly located

Tuner sound distorts and/or volume level is too low

3. The antenna is set in the proper direction
4. The antenna is adequate to receive the desired station

Tuner is intermittent or continuously buzzing or hissing

1. The unit is away from fluorescent lights, TVs, motors and other electrical appliances
2. Other components are not causing interference. Try rearranging the order components are 

stacked in or unplugging/disconnecting components until the interference stops

Stations cannot be preset

1. After pressing the Memory button, the PRESET button on the remote is

pressed while the MEMORY indicator blinks.

AVR10 engelsk  11/01/98 10:11  Side 16