AVR 10 (serv.man7) - Harman Kardon Audio User Guide / Operation Manual. Page 14

12

ENGLISH

1. Press the POWER button to ON.

The display panel will light up.
Note: If you prefer to turn the unit
off and on with the remote control,
this button must be left in the ON
position. The remotes Standby
button will then turn the unit ”ON”
and ”OFF” by taking it in and out of
standby mode.

2. Select the desired program source

with the INPUT FUNCTION
SELECTOR buttons. The selected
input function will appear in the
display.

3. Operate the selected component

for playback.
• When a video source is selected,

the picture will appear on the
television and sound will be
heard from the speakers.

• When playing back a video

source with surround sound
effects, refer to the “Surround
Sound Effects” of this manual.

• When the TAPE MONITOR button

is set to ON so that the TAPE
MONITOR indicator lights up,
selected program sources other
than TAPE cannot be heard from
the speakers.
To listen to a program source
other than cassette deck be sure
to set the TAPE MONITOR button
to OFF.

4. Adjust the volume to a comfortable

listening level with the VOLUME
control or MASTER VOLUME
UP/DOWN buttons on the remote
control.

5. For private listening, insert a 6,3

mm plug of the headphone into the
HEADPHONE jack.

• When the headphones are

plugged in, sound from the
speakers is cut off.

Press the AM or FM button and use
auto, manual or preset tuning to
select a radio station.

If broadcast signals are strong
enough, auto tuning is possible.

1. Press the FM or AM button to

select the desired band.

2. Press the Seek Stereo button so

that AUTO lights up in the display.

3. Press the UP or DOWN

TUNE/PRESET button. Tuning will
start automatically and stop at a
broadcast station frequency with
sufficient signal strength.

Auto tuning may not be possible if the
broadcast signal is weak. If so, use
manual tuning.

1. Press the FM or AM button to

select the desired band.

2. Press SEEK STEREO to delete the

AUTO in the display.

3. Press the UP or DOWN

TUNE/PRESET button until the
desired station frequency is
reached.

• Each time the button is pressed,

the frequency changes by a step.

• When the button is kept pressed,

the frequency changes
continuously in sequence.

The receiver has a memory for up to
30 preset stations.
If the station frequencies are stored in
this memory, they can be tuned in by
a simplified procedure:

Up to 30 stations can be preset at
random, regardless of the reception
band.

1. Tune in the station to be stored in

memory using the auto or manual
tuning.

2. Press the MEMORY button. The

MEMORY indicator will light up for
5 seconds.

3. Select the preset number with the

UP or DOWN TUNE/PRESET
button or the numeric buttons on
the remote while the MEMORY
indicator is lit.

4. Press the MEMORY button to store

the station.

• When using the NUMERIC

buttons on the remote, the
station is stored in memory
without pressing the MEMORY
button again.

• When selecting single digit preset

numbers with the NUMERIC
buttons on the remote, press the
corresponding number without
pressing ”0” first.

5. Repeat steps 1 to 4 to preset other

stations.

AVR10 engelsk  11/01/98 10:10  Side 12