AVI 250 (serv.man9) - Harman Kardon Audio User Guide / Operation Manual. Page 10

Front Panel Controls

4

1 Information Display:

This display

delivers messages and status
indications to help you operate the
receiver. Refer to the separate
diagram for complete explanation of
the FL display.

2 Remote Sensor Window: The
sensor behind this window receives
infrared signals from the remote
control. Aim the remote at this area
and do not block or cover it unless an
external remote sensor is installed.

3 Tuner: Press this button to select
your tuner.

4 CD: Press this button to select
your CD player.

5 Tape1/ Monitor: Press this button
to select Tape One as the input
source. A red LED above the button
will illuminate to indicate that the Tape
Monitor has been selected.

6 Tape 2: Press this button to select
Tape 2.

7 Video Sources: Press any of
these buttons to select a video input
source.

8 Aux: Press this button to select the
source connected to the front panel
Aux jacks.

9 Multiroom Audio Select: Press
this button to turn on the feed to the
remote zone. The remote zone will
stay on after the main power switch is
turned off until it is switched off by the
remote room control or by pressing
this button again.

) Display: Press this button to
turn off the front panel FL display. The

DISP

indicator will illuminate

to remind you that the unit is still
turned on.

! OSD (On Screen Display): Press
the button briefly to display a system
status report on your video screen.

@ Delay: Press this button to adjust
the delay to the rear (surround)
channels.

# Mode: Press these buttons to
scroll up 

⁄

or down 

¤

through the

list of available surround modes.

$ Mute: Press this button to cut the
output to the speakers. Press it again
to return to the previous volume level.

% Volume Control: Turn the knob
clockwise to increase volume,
counterclockwise to decrease the
volume. Note that approximately two
revolutions of the knob are required to
go from no output to maximum
volume.

^ Power: Press this button to turn
the unit on or off.

& Headphone Jack: Plug standard
stereo headphones into this jack for
private listening.

NOTE: When the headphones are in
use the output to the speakers is
muted and the surround mode is
automatically switched to 

STEREO

.

When the headphones are removed
from the jack, sound to the speakers
is restored and the unit returns to the
previous sound mode.

* 6 Channel Direct: Press this
button to select the output of an
external multichannel audio adapter.

( Tape 1 Copy: Press this button to
select the input for the recorder
connected to Tape 1. The first press
will select the source currently being
listened to. Press again to select the
input in the following order:
Tuner‡CD‡Tape 2‡Source.

Ó VCR 1 Copy: Press this button 
to select the input to the recorder
connected to VCR 1. The first 
press selects the input currently being
viewed. Press the button again to
select the input in the 
following order:
TV‡LD‡VCR2‡AUX‡Source

Ô Bass: This knob adjusts the tone
of low frequency sounds. 
Turn it to the right to boost bass 
frequencies or to the left to cut bass
frequencies.

 Treble: This knob adjusts 
the tone of high frequency sounds. 
Turn it to the right to boost high 
frequencies or to the left to cut high
frequencies.

Ò Front Panel Inputs: Audio or
Video sources connected to these
jacks may be selected by pressing the
Aux button 

8.

Engelsk manual AVI250  11/01/98 8:52  Side 4