Read Sony KV-SZ292M88 Service Manual online
– 6 –
KV-SZ292M88/M91
RM-GA002
1-7.
PICTURE TUBE REMOVAL
Note:
•
Please make sure the TV set is not in standing position before removing necessary CRT support located on bottom
right and left.
right and left.
1) Remove the rear cover.
2) Unplug all interconnecting leads from the Deflection yoke, Neck assy, Degaussing Coil and CRT grounding strap.
2) Unplug all interconnecting leads from the Deflection yoke, Neck assy, Degaussing Coil and CRT grounding strap.
Remove Chassis Assy.
3) Place the TV set with the CRT face down on a cushion jig.
• REMOVAL OF ANODE-CAP
Note:
• After removing the anode, short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or
carbon paint on the CRT.
•
REMOVING PROCEDURES
1
Turn up one side of the rubber cap in the direction
indicated by the arrow
indicated by the arrow
a
.
2
Using a thumb pull up the rubber cap firmly in the direction
indicated by the arrow
indicated by the arrow
b
.
3
When one side of the rubber cap is separated from the
anode button, the anode-cap can be removed by turning
up the rubber cap and pulling it up in the direction of the
arrow
anode button, the anode-cap can be removed by turning
up the rubber cap and pulling it up in the direction of the
arrow
c
.
•
HOW TO HANDLE AN ANODE-CAP
1
Do not damage the surface of anode-caps with sharp
shaped objects.
shaped objects.
2
Do not press the rubber too hard so as not to damage
the inside of anode-cap.
A metal fitting called the shatter-hook terminal is built
into the rubber.
the inside of anode-cap.
A metal fitting called the shatter-hook terminal is built
into the rubber.
3
Do not turn the foot of rubber over too hard.
The shatter-hook terminal will stick out or damage the
rubber.
The shatter-hook terminal will stick out or damage the
rubber.
a
a
b
b
c
Anode Button
qs
Loosen the Deflection Yoke
fixing screw and remove
9
Earth Coating Assy
4
Anode Cap Removal
6
Band, DGC Removal (x1)
0
CV Board Removal
qa
Loosen the Neck Assembly
fixing screw and removal
5
Holder, DGC Removal (x2)
8
Spring Tension Removal (x2)
qf
Screw Tapping
7+ Crown Washer
7
Degaussing Coil
qd
Supports, CRT(2) Removal
Click on the first or last page to see other KV-SZ292M88 service manuals if exist.