Read Sony KV-29FS150 Service Manual online
KV-29FS150
KV-29FS150
13
The following adjustments should be made when a complete realignment
is required or a new picture tube is installed.
is required or a new picture tube is installed.
These adjustments should be performed with rated power supply voltage
unless otherwise noted.
unless otherwise noted.
Set the controls as follows unless otherwise noted:
Picture control
Picture control
NORMAL
Brightness control NORMAL
SECTION 2: SET-UP ADJUSTMENTS
Perform the adjustments in order as follows:
1.
1.
Beam
Landing
2.
Convergence
3.
Focus
4.
Screen
(G2)
5.
White
Balance
Note Test Equipment Required:
1.
Color Bar Pattern Generator
2.
Degausser
3.
DC Power Supply
4.
Digital
Multimeter
2-1. BEAM LANDING
Before beginning adjustment procedure:
1. Feed in the white pattern signal.
2. In order to reduce the geomagnetism on the set’s picture tube, face
it east or west.
Adjustment Procedure
1. Input a raster signal with the pattern generator.
2. Loosen the defl ection yoke (DY) mounting screw, and set the purity
control to the center as shown below:
Purity control
3. Position the VM coil as shown below:
VM coil
G2
G1
G3
Align the edge of
the VM coil with
the edge of the G3 grid.
the VM coil with
the edge of the G3 grid.
G4
4. Set the raster signal of the pattern generator to green.
5. Move the defl ection yoke backward, and adjust with the purity
control so that green is in the center and red and blue are even on
both sides.
both sides.
Red
Blue
Green
6. Move the defl ection yoke forward, and adjust so that the entire
screen becomes green.
7. Switch over the raster signal to red, then blue and confi rm the
condition.
8. When the position of the defl ection yoke is determined, tighten it
with the defl ection yoke mounting screw.
9. If landing at the corner is not right, adjust by using the disk
magnets.
a
b
b
c
c
d
d
a
Purity control
corrects this area.
corrects this area.
Disc magnets or rotatable
disc magnets correct these
areas (a-d).
disc magnets correct these
areas (a-d).
Deflection yoke positioning
corrects these areas.
corrects these areas.
5.
Oscilloscope
6.
Landing
Checker
7.
XCV
Adjuster
Click on the first or last page to see other KV-29FS150 service manuals if exist.