KV-24FS100 (serv.man2) - Sony TV Service Manual (repair manual). Page 2

Before performing this adjustment, perform Horizontal  and Vertical 

Static Convergence Adjustment.

1.  Slightly loosen deflection yoke screw.
2.  Remove deflection yoke spacers.
3.  Move the deflection yoke for best convergence as  

 

shown below:

B

G

R

G

B

R

G

B

R

R

R

G

B

G

B

G

B

R

B

G

R

G

B

G

B

R

R

G

B

G

G

B

R B

R

R

4.  Tighten the deflection yoke screw.
5.  Install the deflection yoke spacers.

1.  Input crosshatch pattern.
2.  Adjust PICTURE QUALITY to standard, PICTURE and 

BRIGHTNESS to 50%, and OTHER to standard.

3  Adjust the Horizontal Convergence of red and blue dots by tilting 

the TLH plate on the deflection yoke.

(TLV)

YCH

XCV

TLV

CV

Board

RV1750

 V.STAT

TLH Plate

  B R      R B

(R)(B)  (B)(R)

TLH+

TLH-

4.  Adjust XCV core to balance X axis.
5.  Adjust YCH VR to balance Y axis.
6.  Adjust vertical red and blue convergence with V.TILT (TLV VR.) 
  Note: Perform adjustment 3-6 while tracking items 1 and 2.

1.  Affix a permalloy assembly corresponding to the misconverged 

areas: 

b

a

c

d

a

b

d

a-d: screen-corner

misconvergence

c

1.  Adjust FOCUS control for best pictures.

1.  Input a dot pattern.
2.  Set the PICTURE and BRIGHTNESS controls at minimum and 

COLOR control at normal.

3.  Adjust SBRT, GCUT, BCUT in service mode with an oscilloscope as 

shown below so that voltages on the red, green, and blue cathodes 

are 160 ± 2VDC.

4.  Observe the screen and adjust SCREEN (G2) VR in FBT to obtain 

the faintly visible background of dot signal. 

Focus (FV)

Screen (G2)

Pedestal

160 ± 2VDC

Ground

±

