Read Sony KP-53V100 Service Manual online
— 7 —
KP-53V100
SELF-DIAGNOSTIC FUNCTION
The units in this manual contain a self-diagnostic function. If an error occurs, the STANDBY/TIMER LED will automatically begin to flash. The number
of times the LED flashes translates to a probable source of the problem. A definition of the STANDBY/TIMER LED flash indicators is listed in the
instruction manual for the user’s knowledge and reference. If an error symptom cannot be reproduced, the Remote Commander can be used to review
the failure occurrence data stored in memory to reveal past problems and how often these problems occur.
Diagnostic Test Indicators
When an error occurs, the STANDBY/TIMER LED will flash a set number of times to indicate the possible cause of the problem. If there is more than
one error, the LED will identify the first of the problem areas.
Results for all of the following diagnostic items are displayed on screen. If the screen displays a “0”, an error has occurred.
Diagnostic Item
STANDBY/
Possible Problem Location
Condition
Detected Symptoms
TIMER
flashes
Power not On
0
[Standby Power Supply System]
Cannot turn on the power
F601 open
LED doesn’t blink
R607 open
Q601 short circuit
[Main Power Supply System}
IC601 and R612 are broken
VDR601 short-circuit
+B OCP Detection
2 times
Short circuit of power supply in each circuit
Goes to the standby mode
2: +B OCP 000
Short circuit of the +B line
+B OVP Detection
3 times
T603 pin 7 to pin 8 is open
Goes to the standby mode
3: +B OVP 000
Vertical Deflection Stop
4 times
IC 1509 (V OUT) is broken
Raster goes to one line horizontally
4: V Stop 000
Q1505 (V Pulse Buffer) is broken
A and then video signal is muted.
Video Out Abnormality
5 times
Video Out, Q705, 732, 761, and others in C board
STANDBY/TIMER LED blinks approx.
5: AKB 000
Detection
30 secs, then blinks for the diagnosis
Horizontal Deflection Stop
6 times
C515, 516 open. IC206 (YC Jungle) is broken.
Raster does not appear.
6: H Stop 000
Audio Abnormality
8 times
IC 406 (Audio amp.) is broken.
The sound is not out.
8: Audio 000
Detection
PS401, 402 open
Goes to the standby mode
Note: 000 the range of values for number of operations is 000 - 255. For 256 or higher, the number remains as 255.
Display of Standby/Timer LED Flash Count
�����������
�����������������������
�����������
�����������
���������������������
����������������������
���������
�����������������
����������������
�����������������
�������
���������������
�������
�������������������������
�������
��������
�����������
������
�����
��������������
�
�
�������
�
�
*
������������������������������������������
Release of STANDBY/TIMER indicator blinking.
The STANDBY/TIMER indicator blinking display is released by turning OFF the power switch on the TV main unit or removing the plug from the power.
Self Diagnosis
Supported model
Click on the first or last page to see other KP-53V100 service manuals if exist.