KP-48V75, KP-53V75, KP-61V75 - Sony TV Service Manual (repair manual). Page 5

Read Sony KP-48V75 / KP-53V75 / KP-61V75 Service Manual online

– 5 –
SECTION 1
GENERAL
The operating instructions mentioned here partial abstracts from the
Operating Instructions Manual. The page numbers of the Operating
Instruction Manual remain as in the manual.(part.no : 3-862-729-11)
Getting Started
5
-EN
EN
Carrying your projection TV
p
KP-48V75/53V75 only
Be sure to grasp the areas indicated when carrying the
projection TV, and to use more than two people.
p
KP-61V75 only
Carry your projection TV by the casters.
Preparing for your projection TV
Before you use your projection TV, adjust convergence.
For the procedure, see “Step 4: Setting up the projection
TV automatically (AUTO SET UP)” on page 
21
.
Getting Started
Step 1: Installing
the projection TV
For the best picture quality, install the projection TV
within the areas shown below.
Optimum viewing area (Horizontal)
Optimum viewing area (Vertical)
(Rear of projection TV)
min. 2.1m (approx. 7 ft.)
   53"
min. 1.8m (approx. 6 ft.)
   48"
min. 2.4m (approx. 8 ft.)
    61"
60¡
60°
60°
min. 2.1m (approx. 7 ft.)
53"
min. 1.8m (approx. 6 ft.)
48"
min. 2.4m (approx. 8 ft.)
61"
20°
20°
6
-EN
Getting Started
Step 2: Hookup
Connecting an antenna/cable TV
system without a VCR
To cable or antenna
Although you can use either an indoor or outdoor
antenna with your projection TV, we recommend that
you connect an outdoor antenna or a cable TV system
to get better picture quality.
Connecting an antenna
Connect your antenna cable to the VHF/UHF antenna
terminal. If you cannot connect your antenna cable
directly to the terminal, follow one of the instructions
below depending on your cable type.
To cable box and cable
Pay cable TV systems use scrambled or encoded signals
requiring a cable box* in addition to the normal cable
connection.
* The cable box will be supplied by the cable company.
N o t e
• You cannot watch the signal through an AUX connector as a
window picture.
To cable and antenna
N o t e
• Do not connect anything to the TO CONVERTER connector in
this case.
A
75-ohm coaxial cable
B
• VHF only
or
• UHF only
or
• VHF/UHF
C
Notes
• Most VHF/UHF combination antennas have a signal splitter.
Remove the splitter before attaching the appropriate connector.
• If you use the U/V mixer, snow and noise may appear in the
picture when viewing cable TV channels over 37.
EAC-66 U/V mixer
(not supplied)
• VHF
and
• UHF
75-ohm coaxial cable
300-ohm twin lead cable
300-ohm twin lead cable
Antenna connector
• VHF only
or
• VHF/UHF
or
• Cable
(Rear of projection TV)
     VHF/UHF
(Rear of projection TV)
      VHF/UHF
(Rear of projection TV)
     VHF/UHF
Cable
To cable box
If your cable company requires you to connect a cable
box, make the connection as follows:
(Rear of projection TV)
     VHF/UHF
(Rear of projection TV)
     VHF/UHF
 Cable
Cable box
IN
 OUT
CATV cable
75-ohm coaxial
cable (not supplied)
Cable box
TO
CONVERTER
VHF/UHF
(Rear of projection TV)
AUX
CATV cable
Antenna cable
TO
CONVERTER
VHF/UHF
(Rear of projection TV)
AUX
Page of 97
Display

Click on the first or last page to see other KP-48V75 / KP-53V75 / KP-61V75 service manuals if exist.