Read Sony KDE-W50A12U / KE-W50A10E Service Manual online
– 17 –
AT2X
RM-EA001 / RM-ED001
No colour on programmes
• Select “Reset” in the “Picture Adjustment” menu to return to the factory
settings (page 22).
No colour or irregular colour
when viewing a signal from the
Y, PB/CB, PR/CR jacks of
when viewing a signal from the
Y, PB/CB, PR/CR jacks of
4
• Check the connection of the Y, P
B
/C
B
, P
R
/C
R
jacks of
4.
• Make sure that the Y, P
B
/C
B
, P
R
/C
R
jacks of
4 are firmly seated in their
respective sockets.
Sound
Problem
Cause/Remedy
No sound, but good picture
• Press
2 +/– or % (Mute).
• Check that “Speaker” is set to “On” in the “Features” menu (page 26).
Noisy sound
• See the “Picture noise” causes/remedies on page 40.
Audio distortion
• See “Audio Filter” on page 31.
Channels
Problem
Cause/Remedy
The desired channel cannot be
selected
selected
• Switch between digital and analogue mode and select the desired digital/
analogue channel.
Some channels are blank
• Scrambled/Subscription only channel. Subscribe to the Pay Per View
service.
• Channel is used only for data (no picture or sound).
• Contact the broadcaster for transmission details.
• Contact the broadcaster for transmission details.
Digital channel is not displayed
• Check that the aerial is plugged directly into the TV (not through other
equipment).
• Contact a local installer to find out if digital transmissions are provided in
your area.
• Upgrade to a higher gain aerial.
Problem
Cause/Remedy
Continued
General
Problem
Cause/Remedy
The TV turns off automatically
(the TV enters standby mode)
(the TV enters standby mode)
• Check if the Sleep Timer function is activated (page 28).
• Check if the Auto Shutoff is activated (page 28).
• If no signal is received or no operation is performed in the TV mode for 10
• Check if the Auto Shutoff is activated (page 28).
• If no signal is received or no operation is performed in the TV mode for 10
minutes, the TV automatically switches to standby mode.
Some input sources cannot be
selected
selected
• Select “AV Preset” in the “Set Up” menu and cancel “Skip” of the input
source (page 30).
The remote does not function
• Check that the remote is set correctly for the equipment you are using.
• If the remote does not operate the equipment even when the remote has been
• If the remote does not operate the equipment even when the remote has been
set correctly to VCR or DVD, enter the necessary code set as explained in
“Programming the remote” (page 37).
“Programming the remote” (page 37).
• Replace the batteries.
The
1 (standby) indicator
flashes
• Digital programme is set for “Timer REC”. For details, see “Checking the
Digital Electronic Programme Guide (EPG)” on page 16.
Click on the first or last page to see other KDE-W50A12U / KE-W50A10E service manuals if exist.