Read Sony VPL-HS51A / VPL-HS60 Service Manual online
1-3
VPL-HS60/HS51A
Removal (VPL-HS51A)
1.
1.
Remove the base assembly. (Refer to Section 1-3-1.)
2.
Remove the screw and disconnect the two harnesses
from the connector (CN1806, 1903) on the C board,
then remove the front panel (D).
from the connector (CN1806, 1903) on the C board,
then remove the front panel (D).
3.
Remove the two screws, them remove the Q board
assembly.
assembly.
4.
Remove the front panel (U) assembly from the three
projections of the top panel assembly in the direction
shown by the arrow.
projections of the top panel assembly in the direction
shown by the arrow.
Installation (VPL-HS51A)
5.
5.
Attach the front panel (D) assembly and front panel
(U) assembly in the reverse order of steps 2 to 4.
(U) assembly in the reverse order of steps 2 to 4.
6.
Attach the base assembly.
BTP
3
3
x 12
BTP
3
3
x 12
Q board
assembly
assembly
C board
Harnesses
Front panel (D)
assembly
assembly
Front panel (U)
assembly
assembly
Projections
Projection
Top panel assembly
CN1903
CN1806
Portions A
Rear cover
F board
CN11
AC inlet
Bracket
(AC)
(AC)
Connector panel
assembly
assembly
PSW
4
x 8
K3
x 6
BTP
3
x 12
BTP
3
x 12
Harness
Harnesses
(GND)
(GND)
1-3-3. Rear Cover/Rear Panel
Removal
1.
1.
Remove the base assembly. (Refer to Section 1-3-1.)
2.
Push the three portions A of the rear cover, then remove
the rear cover in the direction shown by the arrow.
the rear cover in the direction shown by the arrow.
3.
Remove the screw (BTP3
x 12), then remove the
connector panel assembly.
4.
Disconnect the harness from the connector (CN11) on
the F board.
the F board.
5.
Remove the two screws (BTP3
x 12), then remove the
bracket (AC).
6.
Remove the two screws (PSW4
x 8), then disconnect
the two harnesses (GND) from the bracket (AC).
7.
Remove the two screws (K3
x 6), then remove the AC
inlet.
Click on the first or last page to see other VPL-HS51A / VPL-HS60 service manuals if exist.