Read Sony MHS-CM5 Service Manual online
MHS-CM5
2-2
先端の剥がれたメッキ部はカットして
除去してください。
(メッキ破片がコネクタ内に残っている
場合もあるので注意してください)
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
– ENGLISH –
– JAPANESE –
NOTE FOR REPAIR
• Make sure that the flat cable and flexible board are not cracked of
bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, don’t pull at wire of connector. It is pos-
sible that a wire is snapped.
• When installing a connector, don’t press down at wire of connector.
It is possible that a wire is snapped.
• Do not apply excessive load to the gilded flexible board.
• フラットケーブルおよびフレキシブル基板の端子面に欠け,折れ
等がないことを確認する。
また,コネクタへの接続は,差し込み不足や斜め差しにならない
ように注意する。
• コネクタを取り外す時に,線材部(極細)を持って引っ張ると断線
する恐れがありますので,絶対に線材部(極細)を持って引っ張ら
ないでください。
• 線材部(極細)を押さえながらコネクタを差し込むと,線材部(極
細)が断線する恐れがありますので,絶対に線材部(極細)には負
担をかけないでください。
• 金メッキされているフレキシブル基板には,強い負担をかけない
でください。
修理時の注意
Click on the first or last page to see other MHS-CM5 service manuals if exist.