Read Sony HDR-HC1 / HDR-HC1E / HDR-HC1EK / HDR-HC1K (serv.man2) Service Manual online
1-4
HDR-HC1/HC1E/HC1K/HC1EK_L2
ENGLISH
JAPANESE
ENGLISH
JAPANESE
E
E
E
E
E
E
Block
Function
6
1
6
1
6
1
6
2
6
2
9
1
Detailed
Code
0
0
1
0
1
1
0
0
0
1
0
1
Symptom/State
Difficult to adjust focus
(Cannot initialize focus.)
(Cannot initialize focus.)
Zoom operations fault
(Cannot initialize zoom lens.)
(Cannot initialize zoom lens.)
Focus lens initializing failure and zoom
lens initializing failure occur simulta-
neously.
lens initializing failure occur simulta-
neously.
Steadyshot function does not work well.
(With pitch angular velocity sensor output
stopped.)
(With pitch angular velocity sensor output
stopped.)
Steadyshot function does not work well.
(With yaw angular velocity sensor output
stopped.)
(With yaw angular velocity sensor output
stopped.)
Abnormality when flash is being charged.
Self-diagnosis Code
Repaired b
y:
Correction
Inspect the lens block focus MR sensor (Pin ql, wa of CN7006 of
NN-001 board) when focusing is performed when the focus ring is
rotated in the focus manual mode and the focus motor drive circuit
(IC7201 of NN-001 board) when the focusing is not performed.
NN-001 board) when focusing is performed when the focus ring is
rotated in the focus manual mode and the focus motor drive circuit
(IC7201 of NN-001 board) when the focusing is not performed.
Inspect the lens block zoom MR sensor (Pin qh, qj of CN7006 of
NN-001 board) when zooming is performed when the zoom switch
is operated and the zoom motor drive circuit (IC7201 of NN-001
board) when zooming is not performed.
NN-001 board) when zooming is performed when the zoom switch
is operated and the zoom motor drive circuit (IC7201 of NN-001
board) when zooming is not performed.
Inspect the flexible board for breakage or loose connection.
If not faulty, inspect the focus and zoom motor drive circuit (IC7201
of NN-001 board).
If not faulty, inspect the focus and zoom motor drive circuit (IC7201
of NN-001 board).
Inspect pitch angular velocity sensor (SE6802 of EE-001 board)
peripheral circuits.
peripheral circuits.
Inspect yaw angular velocity sensor (SE6801 of EE-001 board)
peripheral circuits.
peripheral circuits.
Checking of flash unit or replacement of flash unit. (Note)
1-6. PROCESS AFTER FIXING FLASH ERROR
When “FLASH error” (Self-diagnosis Code E:91:**) occurs, to prevent any abnormal situation caused by high voltage, setting of the flash is
changed automatically to disabling charge and flash setting.
After fixing, this setting needs to be deactivated. Connect the adjustment remote commander and perform the following process.
changed automatically to disabling charge and flash setting.
After fixing, this setting needs to be deactivated. Connect the adjustment remote commander and perform the following process.
Order Page Address Data
Procedure
1
7
01
75
2
7
00
01
Press PAUSE button.
3
7
02
Check the data changes to “01”.
Note:
After repair, be sure to perform “1-6. PROCESS AFTER FIXING FLASH ERROR”.
Click on the first or last page to see other HDR-HC1 / HDR-HC1E / HDR-HC1EK / HDR-HC1K (serv.man2) service manuals if exist.