DCR-TRV240E, DCR-TRV340E (serv.man3) - Sony Movie Service Manual (repair manual). Page 121

5-8

Note1: When reading or writing the 1B, 1C, 1D page data, select page: 0,

address: 10, and set data: 01, then select B, C or D page. The 1B.
1C or 1D page can be chosen by this data setting.
After reading or writing, reset the data of page: 0, address: 10 to
“00”.

Note2: The A, B and 1B page are DCR-TRV340E model only.

[Connection of the power supply during the initialization
of the data.]
1)

Connect the regulated power supply and the digital voltmeter
to the battery terminal as shown in Fig. 5-1-6.

2)

Adjust the output voltage of the regulated power supply so that
the digital voltmeter display is 6.1 ± 0.1Vdc.

3)

Turn off the power supply.

4)

Turn on the HOLD switch of the adjusting remote commander.

5)

Turn on the power supply.

6)

Perform the initialization of the data.

Note3: This is normal though the following message is indicated on the

LCD screen.

“FOR InfoLITHIUM BATTERY ONLY”

[Initialization Procedure]
DCR-TRV240E:
1.

Initialization of D page data

2.

Initialization of 8, C, 1C page data

3.

Initialization of E, F, 1F page data

DCR-TRV340E:
1.

Initialization of A, D page data

2.

Initialization of B, 1B page data

3.

Initialization of 8, C, 1C page data

4.

Initialization of E, F, 1F page data

Digital voltmeter

Regulated power supply

Battery terminal

Fig. 5-1-6.