DCR-TRV240E, DCR-TRV340E (serv.man3) - Sony Movie Service Manual (repair manual). Page 118

5-5

Fig. 5-1-2.

Note1: For details of how remove the cabinet and boards, refer to “2.

DISASSEMBLY”.

Note2: When performing only the adjustments, the lens block and boards

need not be disassembled.

Note3: Before performing the adjustments, check the data of page: 0,

address: 10 is “00”. If not, set data: 00 to this address.

1)

Connect the equipment for adjustments according to Fig. 5-1-3.

2)

The front panel block (SI-032 board (Microphone amp, remote
commander receiver), FP-411 flexible (MIC jack, Headphone
jack, LANC jack, MF photo sensor)) must be assembled for
connecting the adjustment remote commander.

Note4: Only for DCR-TRV240E model, as removing the cabinet (R)

(removing the VC-276 board CN1110) means removing the lithium
3V power supply (CF-2500 block BT001), data such as date, time,
user-set menus will be lost. After completing adjustments, reset
these data. If the cabinet (R) has been removed, the self-diagnosis
data, data on history of use (total drum rotation time etc. ) will be
lost. Before removing, note down the self-diagnosis data (data of
page: 2, address: B0 to C6) and data on history use (data of page:
2, address: A5 to AA). (Refer to “5-4. Service Mode” for the self-
diagnosis data and data on the history use.)

Note5: Setting the “Forced Camera Power ON” Mode

1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 10, set data: 01, and press the PAUSE

button.

The above procedure will enable the camera power to be turned
on with the SS-1380 block removed. After completing adjustments,
be sure to exit the “Forced Camera Power ON Mode”.

Note6: Exiting the “Forced Camera Power ON” Mode

1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 10, set data: 00, and press the PAUSE

button.

3) Select page: 0, address: 01, and set data: 00.

Front of the lens

1.5 m

Pattern box