DCR-PC103E, DCR-PC104E, DCR-PC105, DCR-PC105E (serv.man8) - Sony Movie Service Manual (repair manual). Page 2

— 2 —

In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (8.4V), the power is shut off so
that the unit cannot operate.
This following two methods are available to prevent this. Take note of which to use during repairs.

Use the AC power adaptor (AC-L10, AC-VQ800 etc.).

Connect the servicing remote commander RM-95 (J-6082-053-B) to the LANC jack, and set the commander switch to the “ADJ” side.

1

Only for DCR-PC105/PC105E, open the flash.

2

Only for DCR-PC105/PC105E, refer to “3. DISCHARGING OF THE FLASHLIGHT POWER SUPPLY CAPACITOR” to discharge
the flash power supply capacitor.

3

Refer to page 2-3, 2-4 to remove the cabinet (front) assembly, cabinet (G) assembly and cabinet (L).

4

Refer to page 2-5 to remove the cabinet (R) section.

5

Refer to page 2-11, 2-14 to remove the cabinet (rear), control switch block (PS4400).

6

Refer to page 2-12, 2-13 to remove the ST-084 board and LENS/EVF/ST section.

7

Refer to page 2-22, 2-23 to remove the VC-319 board and mechanism deck (Z100).

8

Supply +4.5V from the DC power supply to the loading motor and unload with a pressing the cassette compartment.

1

Refer to page 2-3, 2-4 to remove cabinet (G) assembly and cabinet (L).

2

Push the part pointed out with the arrow in the direction of the arrow.

DC power supply (+4.5Vdc)

Loading motor

Exchange page 1-1 and page1-2 of Service Manual with page 2 and
page 3 of this Correction-1.