Read Sony DCR-DVD110E / DCR-DVD115E / DCR-DVD310E / DCR-DVD410E / DCR-DVD610 / DCR-DVD610E / DCR-DVD710 / DCR-DVD710E / DCR-DVD810 / DCR-DVD810E (serv.man2) Service Manual online
1-1
ENGLISH
JAPANESE
ENGLISH
JAPANESE
DCR-DVD110E/DVD115E/DVD310E/DVD410E/DVD610/
DVD610E/DVD710/DVD710E/DVD810/DVD810E_L2
DVD610E/DVD710/DVD710E/DVD810/DVD810E_L2
1. SERVICE NOTE
1-1. POWER SUPPLY DURING REPAIRS
In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (8.4 V), the power is shut off so
that the unit cannot operate.
These following method is available to prevent this.
that the unit cannot operate.
These following method is available to prevent this.
Method:
Use the AC power adaptor (AC-L200/L200B).
1-2. TO TAKE OUT A DISC WHEN NOT EJECT (FORCE EJECT)
1
Open the jack cover and remove the remote control window.
2
Insert the wire etc. in the hole and down the eject slider by it.
1-3. PRECAUTION ON REPLACING THE VC-520 BOARD
DESTINATION DATA
When you replace to the repairing board, the written destination data of repairing board also might be changed to original setting.
Refer to Service Manual ADJ, and perform “DESTINATION DATA WRITE”.
Refer to Service Manual ADJ, and perform “DESTINATION DATA WRITE”.
USB SERIAL No.
The set is shipped with a unique ID (USB Serial No.) written in it.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
Refer to Service Manual ADJ, and perform “USB SERIAL No. INPUT”.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
Refer to Service Manual ADJ, and perform “USB SERIAL No. INPUT”.
Hole
Remote Control Window
Jack Cover
Charge Lever
Eject Slider
Click on the first or last page to see other DCR-DVD110E / DCR-DVD115E / DCR-DVD310E / DCR-DVD410E / DCR-DVD610 / DCR-DVD610E / DCR-DVD710 / DCR-DVD710E / DCR-DVD810 / DCR-DVD810E (serv.man2) service manuals if exist.