SDM-S76F - Sony Monitor Service Manual (repair manual). Page 10

 

 
To enter service OSD menu, 

1) Turn off the power switch button. 
2) Press “Down” key, and power key simultaneity. 
3) Shows the service OSD menu. That menu is located in down side of main menu. 
4) The service OSD menu contains additional menus as described below. 

 

 
 

 
「COLOR TEMP」 

Adjust R/G/B color values of contrast and brightness in 9300k, 6500k, Use color mode.   
(Factory Setting Area). 

 
「INITIAL EEPROM」 

Initialize the EDID DATA at DDC2B EEPROM is saved system memory. 
COLOR TEMP data becomes the default “128”. User table data is reset. 

 
「CLR. ETI」 

ETＩ  (the used time of MNT) counter shall be reset to 0H by activating this function.   
 

「AGING」 

Enable to set the monitor in the Aging mode or exit from the mode. Select aging mode (On/Off) 

 
「WHITE BALANCE」 

Adjust the offset voltage and gain value in Analog RGB by AUTO. 

 
「DEFAULT TIMING」 

Select the resolution timing of the signal. Menu is 1152×864(VESA standard timing) or   
1152×870(MAC computer timing).    Default is 1152×870. 

 
「MODULE」 

To select applied module 
When you replace A board or Panel, it is required to set the Panel inch size and the Panel maker name on 
selecting “MODULE”.   

                                                                                          10 

                                           

SDM-S76F / SDM-S96F (E)