Read Sony CPD-G520P (serv.man2) Service Manual online
21 inches measured diagonally
Vertical: 1536 lines
Vertical: 1200 lines
TTL 2 k
Vertical: 48 to 170 Hz
provide an optimal image for the screen.
exposed metal parts to any exposed metal part having a return to chassis,
must not exceed 0.5 mA (500 microamperes).
Leakage current can be measured by any one of three methods.
1. A commercial leakage tester, such as the Simpson 229 or RCA WT-
analog meters must have an accurate low-voltage scale. The Simpson 250
and Sanwa SH-63Trd are examples of a passive VOMs that are suitable.
Nearly all battery operated digital multimeters that have a 2 V AC range
are suitable. (See Fig. A)
checks before releasing the set to the customer:
1. Check the area of your repair for unsoldered or poorly-soldered
have replaced all the insulators.
and recommend their replacement.
have low HV.
Parts on Set
DEGAUSS COIL HAS BEEN REMOVED.
PARTS LIST ARE CRITICAL FOR SAFE OPERATION. REPLACE
THESE COMPONENTS WITH SONY PARTS WHOSE PART
NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN
SUPPLEMENTS PUBLISHED BY SONY. CIRCUIT ADJUST-
MENTS THAT ARE CRITICAL FOR SAFE OPERATION ARE
IDENTIFIED IN THIS MANUAL. FOLLOW THESE PROCEDURES
WHENEVER CRITICAL COMPONENTS ARE REPLACED OR IM-
PROPER OPERATION IS SUSPECTED.
DEMAGNETISATION EST ENLEVÉE.
SPECIFIÉ. LES RÉGLAGES DE CIRCUIT DONT L’IMPORTANCE
EST CRITIQUE POUR LA SÉCURITÉ DU FONCTIONNEMENT SONT
IDENTIFIÉS DANS LE PRÉSENT MANUEL. SUIVRE CES
PROCÉDURES LORS DE CHAQUE REMPLACEMENT DE
COMPOSANTS CRITIQUES, OU LORSQU’UN MAUVAIS
FONCTIONNEMENT EST SUSPECTÉ.
reduce power consumption as shown below.
cut and NO SIGNAL appears on the screen before the monitor enters