CPD-G200, CPD-G200P - Sony Monitor Service Manual (repair manual). Page 14

3

When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling up it in
the direction of the arrow 

c

.

1

Don’t scratch the surface of anode-caps with shartp shaped mate-
rial!

2

Don’t press the rubber hardly not to damege inside of anode-caps!
A material fitting called as shatter-hook terminal is built in the
rubber.

3

Don’t turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or damage the rubber.

NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT,

after removing the anode.

1

Turn up one side of the rubber cap in
the direction indicated by the arrow 

a

.

2

Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow 

b

.

3

Two screws
(+BVTP 4 x 16)

5

Base assembly

4

Two screws
(+BVTT 4 x 8)

6

Four screws
(Tapping screw 5)

11

Deflection yoke

10

Neck assembly

8

Degaussing coil assembly

2

A board

9

Two extention springs

1

Anode cap

12

Two degaussing coil holders

13

Two degaussing coil holders

7

Picture tube

Bezel assembly

Cushion

8 pin

2 pin

CN2

CN601

GND

CN904

CN303

2-3