Read Sony CPD-E400 / CPD-E400E / CPD-E400P Service Manual online
CPD-E400/E400E/E400P
2-7. PICTURE TUBE REMOVAL
2-4
CN11
CN801
CN1
2pin
4
Four screws
(Tapping screw (5))
(Tapping screw (5))
3
Three connectors
7
Neck assembly
1
Anode cap
2
A board
8
Deflection yoke
6
Picture tube
5
Bezel assembly
3
When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling up it in the
direction of the arrow
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling up it in the
direction of the arrow
c
.
• HOW TO HANDLE AN ANODE-CAP
1
Don’t scratch the surface of anode-caps with sharp shaped
material!
material!
2
Don’t press the rubber hardly not to damage inside of anode-
caps!
A material fitting called as shatter-hook terminal is built in the
rubber.
caps!
A material fitting called as shatter-hook terminal is built in the
rubber.
3
Don’t turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or damage the rubber.
The shatter-hook terminal will stick out or damage the rubber.
• REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after
removing the anode.
• REMOVING PROCEDURES
1
Turn up one side of the rubber cap in
the direction indicated by the arrow
the direction indicated by the arrow
a
.
2
Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow
firmly in the direction indicated by the
arrow
b
.
a
b
c
Anode Button
Click on the first or last page to see other CPD-E400 / CPD-E400E / CPD-E400P service manuals if exist.