CPD-E240 - Sony Monitor Service Manual (repair manual). Page 8

7

 

 

 

WARNING: High voltage remains in the CRT even after the power is disconnected. To avoid electric shock, discharge CRT before attempting to remove 
the anode cap. After removing the anode cap, short circuit to either the metal chassis, CRT shield, or carbon painted on the CRT. 

1.  Do not use sharp objects which may cause damage to the surface of the 

anode cap. 

2.  To avoid damaging the anode cap, do not squeeze the rubber covering too 

hard. A material Þ tting called a shatter-hook terminalis built into the rubber. 

3.  Do not force turn the foot of the rubber cover. This may cause the shatter-hook 

terminal to protrude and damage the rubber.

Turn up one side of the rubber cap 
inthe direction indicated by arrow  a .

Use your thumb to pull the rubber
cap Þ rmly in the direction indicated
by arrow  b .

When one side of the rubber cap separates from 
the anode button, the anode cap can be removed 
by turning the rubber cap and pulling it in the 
direction of arrow  c .

1

  Place the unit face down on a cushion to avoid 

scratching.

2

  Remove the anode cap.

3

  Remove (4) screws (Screw (5) Tapping) from 

the CRT.

4

  Remove the picture tube shield.

5

  Remove the neck assembly.

6

 Remove the deß ection yoke.

 Remove 

the 

A 

board.

8

  Remove the demagnetization coil.

9

  Remove (2) screws (BVTP 4 x 16) from the 

chassis assembly and slide out to remove.

Anode Button

1

2

3

4

5

6

7

8