Read Sony CPD-420GS Service Manual online
CPD-420GS
—
22
—
—
21
—
—
20
—
—
19
—
5-1. BLOCK DIAGRAM
5-2. CIRCUIT BOARDS LOCATION
Note:
• All capacitors are in
µ
F unless otherwise noted. pF:
µµ
F
50 WV or less are not indicated except for electrolytic.
• Indication of resistance, which does not have one for rating
electrical power, is as follows.
• Indication of resistance, which does not have one for rating
electrical power, is as follows.
• All resistors are in ohms.
•
•
f
: nonflammable resistor.
•
:
fusible resistor.
•
∆
: internal component.
•
p
:
panel designation and adjustment for repair.
•
e :
earth-ground.
•
E :
earth-chassis.
• The components identified by
[ in this basic schematic
diagram have been carefully factory-selected for each set
in order to satisfy regulations regarding X-ray radiation.
Should replacement be required, replace only with the
value originally used.
• When replacing components identified by
in order to satisfy regulations regarding X-ray radiation.
Should replacement be required, replace only with the
value originally used.
• When replacing components identified by
]
,
make the necessary
adjustments by using RV904 (
[) as indicated. (See page 14)
• All variable and adjustable resistors have characteristic curve B,
unless otherwise noted.
unless otherwise noted.
• When replacing parts shown in the table below,
be sure to perform the safety related adjustment.
be sure to perform the safety related adjustment.
Part Replaced (
[)
RV904
Part Replaced (
])
•
All voltages are in volts.
•
Readings are taken with a 10
ΜΩ
digital multimeter
•
Readings are taken with a color-bar signal input.
•
Voltage variations may be noted due to normal
production tolerances.
production tolerances.
• *
: Cannot be measured.
•
Circled numbers are waveform references.
•
: B +bus.
•
: B - bus.
Pitch: 5 mm
Rating electrical power 1/4 W (CHIP: 1/10 W)
Rating electrical power 1/4 W (CHIP: 1/10 W)
Note: The components identified by shading and
mark
¡
are critical for safety. Replace only
with part number specified.
Note: Les composants identifies per un trame et une
marque
marque
¡
sont critiques pour la securite. Ne les
remplacer que par une piece portant le numero specifie.
5-3. SCHEMATIC DIAGRAMS AND PRINTED WIRING BOARDS
D - BOARD
T901, R903, IC805, R921, R922,
R812, D908, IC605, R913, R914,
D802, D909
R812, D908, IC605, R913, R914,
D802, D909
SECTION 5
DIAGRAMS
NOTE:
Portions of this circuit marked as shown are high
voltage areas. Use care to prevent electric shocks
during inspection or repair.
voltage areas. Use care to prevent electric shocks
during inspection or repair.
FOLDOUT 19-22
5/27/99, 10:59 AM
1
Click on the first or last page to see other CPD-420GS service manuals if exist.