CPD-420GS - Sony Monitor Service Manual (repair manual). Page 13

 Turn up one side of the rubber cap in

the direction indicated by arrow 

.

 When one side of the rubber cap sepa-

rates from the anode button, the anode-
cap can be removed by turning the rub-
ber cap and pulling it in the direction of
arrow 

.

 Use your thumb to pull the rubber cap

firmly in the direction indicated by
arrow 

.

NOTE:   Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after
              removing the anode.

 Do not use sharp objects which may cause damage to the surface

of the anode-cap.

 Do not squeeze the rubber covering too hard to avoid damaging

the anode-cap. A material fitting called a shatter-hook terminal is
built into the rubber.

 Do not force turn the foot of the rubber cover. This may cause the

shatter-hook terminal to protrude and damage the rubber.

     Demagnetization coil

     Tension spring

     Stand assy

(D board)

     A board

     Neck assy

     Deflection yoke

     Four screws

(Tapping screw 5)

     Anode cap

Cushion

     Picture tube shield

     Two screws

(BVTP 4 x 16)

1

6

9

10

5

4

3

2

7

8