Read Panasonic ER131 / ER131H520 Service Manual online
Order Number SD0704R34CE
AC/Rechargeable Hair Clipper
Model No. ER131
Russia
TABLE OF CONTENTS
PAGE
PAGE
1 Warning -------------------------------------------------------------- 2
2 Specifications ----------------------------------------------------- 2
3 Troubleshooting Guide ----------------------------------------- 3
4 Disassembly and Assembly Instructions ---------------- 4
5 Wiring Connection Diagram ---------------------------------- 6
6 Schematic Diagram ---------------------------------------------- 6
7 Exploded View and Replacement Parts List ------------ 7
2 Specifications ----------------------------------------------------- 2
3 Troubleshooting Guide ----------------------------------------- 3
4 Disassembly and Assembly Instructions ---------------- 4
5 Wiring Connection Diagram ---------------------------------- 6
6 Schematic Diagram ---------------------------------------------- 6
7 Exploded View and Replacement Parts List ------------ 7
2
1 Warning
Caution:
• Pb free solder has a higher melting point that standard solder; Typicall the melting point is 50 - 70
°F (30 - 40°C) higher. Please
use a soldering iron with temperature control and adjust it to 750 ± 20
°F (400 ± 10°C). In case of using high temperature solder-
ing iron, please be careful not to heat too long.
• Pb free solder will tend to splash when heated too high (about 1100
°F / 600°C).
2 Specifications
3
3 Troubleshooting Guide
4
4 Disassembly and Assembly Instructions
4.1.
Disassembly Instructions
Follow the procedure below to disassemble the main body.
1. Remove the attachment and the blade.
2. Loosen two screws tightening the blade springs and two housing screw.
3. Separate housing A and B by opening at the blade side.
4. Take out the motor and module from housing A.
5. Unsolder the lead wires and separate the motor from the module.
6. Remove the switch handle.
2. Loosen two screws tightening the blade springs and two housing screw.
3. Separate housing A and B by opening at the blade side.
4. Take out the motor and module from housing A.
5. Unsolder the lead wires and separate the motor from the module.
6. Remove the switch handle.
