CPD-220AS - Sony Monitor Service Manual (repair manual). Page 12

– 12 –

3

When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling up it in the
direction of the arrow 

c

.

1

Don’t hurt the surface of anode-caps with shartp shaped material!

2

Don’t press the rubber hardly not to hurt inside of anode-caps!
A material fitting called as shatter-hook terminal is built in the
rubber.

3

Don’t turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or hurt the rubber.

NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after

removing the anode.

1

Turn up one side of the rubber cap in
the direction indicated by the arrow 

a

.

2

Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow 

b

.

     A block

2

     Anode cap

1

     Screw
     (+BVTT 4 x 8)

3

     Cable stopper

4

     Two screws 
     (+BVTP 3 x 12)

7

     Two screws 
     (+BVTP 3 x 12)

5

     Cable blacket 

6

     D board

9

     Two screws
     (+BVTP 3 x 12)

8

GND

GND

GND

CN601

CN503

CN311

CN501

CN607

CN507