CPD-201VS - Sony Monitor Service Manual (repair manual). Page 6

1-2

Functions of Controls

!¡
!™

!£

!¢

!∞

!§
!¶

2

h MIC plug (red)

;

 Video signal cable

2

 Headphones jack

Connect the supplied power cord (page 13).
Connect to the computer’s audio output
(page 12).
Connect to the computer’s microphone input
(page 12).
Connect to the computer’s video output
(page 12).
Connect standard mini-plug headphones (not
supplied). The speakers are turned off when
headphones are connected.
Adjusts the angle of the display (page 15).
Connect to a subwoofer’s input (not supplied).

!¡

!∞

!™

!£

!¢

!§

!¶

Before using this display, please make sure that the following items are
included in your package:
• Multimedia computer display (1)
• Power cord (1)
• Warranty card (1)
• Operating instructions manual (1)
• Windows Monitor Information Disk and its instruction manual (1)

✎

This display will sync with any IBM or compatible system equipped with VGA

1)

 or greater

graphics capability. Although this display will sync to other platforms running at horizontal
frequencies between 30 and 70 kHz, including Macintosh

2)

 and Power Macintosh systems, a

cable adapter is required. Please consult Sony Technical Support for advice on which adapter is
suitable for your needs.

1) VGA is a trademark of IBM Corporation.
2) Macintosh is a trademark of Apple Computer Inc.

Continued to the next page ➔

Getting Started

AL

LINE OUT

USB

CONTR

LINE IN

MIC

MONITOR

PRINTER

2

p

With the computer switched off, connect the video signal cable to the
display (VGA) connector on your computer.  If your computer supports
the DDC plug-and-play standard, this connection will enable DDC
communication between the display and the computer.
The video signal cable is combined with audio and microphone cables.
If your computer is equipped with sound capability, connect the audio
(green) and microphone (red) plugs to appropriate jacks located on your
computer.

✔

Do not touch the pins of the video signal cable.

Computer

Getting Started

Red (to microphone

connector)

Blue (to monitor

connector)

Green (to LINE OUT

connector)

Fasten the
screw of the
blue plug.

Getting Started

to a power outlet

Power cord (supplied)

p

With the display switched off, connect the power cord to the display
and the other end to a power outlet.

p

For proper Plug and Play recognition, turn on the display before you
turn on your computer.

✔

If there is something wrong with the input signal, one of the following messages appears.

“OUT OF SCAN RANGE”
This indicates that the input signal is not supported by the display’s specifications.

“NO INPUT SIGNAL”
This indicates that video signal is missing.

To solve these problems, see “Troubleshooting” on page 36.

p

Adjust the user controls according to your personal preference.

The installation of your display is complete. Enjoy your display.