CPD-201VS - Sony Monitor Service Manual (repair manual). Page 16

2-4

3

When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling up it in
the direction of the arrow 

c

.

1

Don’t hurt the surface of anode-caps with shartp shaped material!

2

Don’t press the rubber hardly not to hurt inside of anode-caps!
A material fitting called as shatter-hook terminal is built in the
rubber.

3

Don’t turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or hurt the rubber.

NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT,

after removing the anode.

1

Turn up one side of the rubber cap in
the direction indicated by the arrow 

a

.

2

Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow 

b

.

Cushion

3

Two screws
(+BVTP 4 x 16)

Four screws
(+BVTT 4 x 8)

10

4

Stand assy

5

8

Four screws
(Tapping screw 5)

Deflection yoke

7

Neck assy

6

A block

CN303

CN304

CN314

CN512

CN501

CN701

GND

GND

2P

CN601

2

Anode cap

1

Picture tube

Picture tube shield

9