Read Sony CPD-120AS Service Manual online
CPD-120AS
– 13 –
3
When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling up it in the
direction of the arrow
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling up it in the
direction of the arrow
c
.
• HOW TO HANDLE AN ANODE-CAP
1
Don’t hurt the surface of anode-caps with shartp shaped material!
2
Don’t press the rubber hardly not to hurt inside of anode-caps!
A material fitting called as shatter-hook terminal is built in the
rubber.
A material fitting called as shatter-hook terminal is built in the
rubber.
3
Don’t turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or hurt the rubber.
The shatter-hook terminal will stick out or hurt the rubber.
• REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after
removing the anode.
• REMOVING PROCEDURES
1
Turn up one side of the rubber cap in
the direction indicated by the arrow
the direction indicated by the arrow
a
.
2
Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow
firmly in the direction indicated by the
arrow
b
.
2-5. PICTURE TUBE REMOVAL
A block
2
Anode cap
1
Two screws
(+BVTP 4 x 16)
(+BVTP 4 x 16)
3
Stand assy
4
Neck assy
5
Deflection yoke
6
Picture tube
8
Four screws
(Tapping screw 5)
(Tapping screw 5)
7
Demagnetization coil
9
Tension spring
10
Two degaussing coil holders
11
Two degaussing coil holders
12
Cushion
a
b
c
Anode Button
Click on the first or last page to see other CPD-120AS service manuals if exist.