Read Sony BDP-S550 Service Manual online
1-1
BDP-S550
SECTION 1
SERVICE NOTE
1-1. DISC REMOVAL PROCEDURE IF THE TRAY CANNOT BE EJECTED (FORCED EJECTION)
1. Remove the side panel (R/L). (Refer to page 2-2)
2. Remove the top panel assy. (Refer to page 2-2)
3. Remove the top shield. (Refer to page 2-3)
4. Insert a clip in the hole of a drive and open a tray.
2. Remove the top panel assy. (Refer to page 2-2)
3. Remove the top shield. (Refer to page 2-3)
4. Insert a clip in the hole of a drive and open a tray.
Note: Use a clip of about 1.2 mm in the diameter
clip
(Use that of about 1.2 mm in the diameter)
(Use that of about 1.2 mm in the diameter)
hole
tray
1-2. Attention at installation of harness (DM-146)
Push at Harness root.
Upper case
Lead pin dressing method change.
From top side.
From top side.
Harness (DM-146) bending height.
Less than Heat-sink height.
Less than Heat-sink height.
Need distance: Over 5 mm.
Actual: Around 12 mm after ben.
Actual: Around 12 mm after ben.
Click on the first or last page to see other BDP-S550 service manuals if exist.