SLT-A58, SLT-A58K, SLT-A58M, SLT-A58Y - Sony Digital Camera Service Manual (repair manual). Page 6

SLT-A58/A58K/A58M/A58Y_L2

1-3

Make sure to confirm below before replacing the AS Slider B Assy T or the AS Holder Actuator Assy.

(1)  Remove the Rear Cover Section, and temporally mount the AS Slider Unit (863).
(2)  Set the AS Slider Unit (863) upwards as shown in figure, and put it on a stable place.

 

(3)  Select “Slider Unit Check” of the adjustment software, and then confirm the movement to the directions of Pitch and Yaw, and if an error occurs,
 

replace it with the component part corresponding to the movement.

 

Make sure to confirm below after replacing the AS Slider B Assy T or the AS Holder Actuator Assy.

(1)  Remove the Rear Cover Section, temporally mount the AS Slider Unit (863) mounted with the Imager Sensor, and then set up the camera 
 

body and hold the AS Slider Unit (863) as shown in figure.

 

(2)  Select “Slider Unit Check” of the adjustment software, and then confirm if the result is OK.
(3)  Select “Tebure Revise Adj.” of the adjustment software, and then confirm if the result is OK.
(4)  Mount the AS Slider Unit (863) to the camera.

 

9)  Check the Destination Ver. window and confirm that the version has been updated.

Destination Ver. window