SLT-A35, SLT-A35K, SLT-A35Y - Sony Digital Camera Service Manual (repair manual). Page 5

SLT-A35/A35K/A35Y_L2

1-2

Make sure to confirm below after replacing the AS Slider B Assy or the AS Holder Actuator Assy.

(1)  Remove the CV Rear Cover Assy (863), temporally mount the AS Slider Unit (863) mounted with the Imager Sensor, and then set up the camera
 

body and hold the AS Slider Unit (863) as shown in figure.

 

(2)  Select “Slider Unit Check” of the adjustment software, and then confirm if the result is OK.
(3)  Select “Tebure Revise Adj.” of the adjustment software, and then confirm if the result is OK.
(4)  Mount the AS Slider Unit (863) to the camera.

 

Note: The actual image may differ from the image shown above.

Removal Procedure
(1)  Remove the spring.

 

Spring

(2)  Remove the solder on the enamel wires at two places.

 

Solder

Solder

(3)  Remove the flexible board from the AS Slider B Assy.

 

Flexible Board

(4)  Remove the two screws.

 

(5)  Remove the AS Unit Holder Ball.

 

AS Unit Holder Ball

(6)  Remove the two Ball Bearings.

 

Ball Bearing

Ball Bearing

(7)  Remove the Cap SPs (for Pitch and Yaw).

 

Cap SP

(8)  Remove the Caps (for Pitch and Yaw).

 

Cap

(9)  Remove the AS Slider A Assy.
 

It can be done easily if A is removed beforehand.

 

AS Slider A Assy

A

(10)  Remove the AS Slider B Assy.
 

It can be done easily if B is removed beforehand.

 

AS Slider B Assy

B

(11)  Remove the three Ball Bearings.

 

Ball Bearing