SAL55300 - Sony Digital Camera Service Manual (repair manual). Page 7

2-4

SAL55300 (DT 4.5-5.6/55-300 SAM) (DT 55-300mm F4.5-5.6 SAM)

Bond (B-10): J-6082-612-A

1.  Install the 1st Group Adjust Washers.
2.  Install the 1st Group Assy while aligning the three projections of the 1st Group Assy with the three notches of the 1st Group Slip Bayonet.
3.  Apply bond (B-10) to the indicated portion, and then install the Retainer.

Apply bond (B-10) to three or
four threads from the eyepiece
side of the 1st Group Slip.

Retainer

1ST Group Adjust Washer

1ST Group Assy

Apply the bond
(B-10)

1ST Group Assy

1ST Group Slip Bayonet

Projections

Notches

Notches

Projection

1.  Turn the Middle Barrel of the Focus Ring Assy clockwise to the maximum.
2.  Turn the lens inside the main unit clockwise to the maximum.
3.  Align the Zoom Encoder Board with the Aperture Function Lever and also align the three claws with the three grooves, and then install 

the Focus Ring Assy to the main unit.

4.  Push portion A of the 1st Group Slip to lock the three claws.
5.  Engage the three bosses with the three boss holes.
6.  Tighten the four screws.

Zoom Encoder Board

Aperture Function Lever

A

Focus Ring Assy

Groove

Groove

Unit

1st Group Slip

Claw

Screws

Claws

Fully turn the Middle Barrel
clockwise. 

Push Portion A to release
the three claws.

Turn the inner lens clockwise
to the maximum.   

Align the bosses with
the boss holes. 

ᴾ