Read Sony SAL20TC Service Manual online
HELP
SAL20TC (2x TELE CONVERTER) (2 X Teleconverter)
HELP15
Adhesive bond (B-10): J-6082-612-A
1.
Stick the tape (such as scotch tape) onto the Preset ring.
2.
Stick it to be positioned at the center of the connect ring. (The space should be the same intervals)
3.
To stabilize the preset ring, add the tape on one or two parts, and assemble the steel balls in order of two steel balls, retainer, and then
one steel ball.
4.
Tighten the preset ring holding plate until it stops lightly.
(Be noted that it is sometimes hard to tighten due to adhesive.)
5.
Remove the tape and loosen the preset ring pressure until the preset ring turns ightly. (about 45 degrees)
6.
Apply the adhesive bond (B-10) at the two parts of the preset ring holding plate.
HELP16
Adhesive bond (B-40): J-6082-614-A
Apply the adhesive bond (B-40) to the screw in figure.
Apply the adhesive bond (B-10)
Apply the adhesive bond (B-10)
Retainer
Tape
Preset Ring Holding Plate
Steel Ball
Preset Ring
Connect Ring
Body A Mount
Screw Nut
Apply the adhesive bond (B-40)
Ver 1.1 2007.01
Click on the first or last page to see other SAL20TC service manuals if exist.