Read Sony SAL14TC Service Manual online
HELP
SAL14TC (1.4x TELE CONVERTER) (1.4 X Teleconverter)
HELP15
Adhesive bond (B-10): J-6082-612-A
Anti-diffusion agent (A-20): J-6082-611-A
1.
Stick the tape (such as scotch tape) onto the Preset ring.
2.
Stick it to be positioned at the center of the connect barrel. (The space should be the same intervals)
3.
To stabilize the preset ring, add the tape on one or two parts, and assemble the steel balls.
4.
Apply the anti-diffusion agent (A-20) to over the preset ring.
5.
Tighten the preset ring holder until it stops lightly.
(Be noted that it is sometimes hard to tighten due to adhesive.)
6.
Remove the tape and loosen the preset ring pressure until the preset ring turns lightly. (about 45 degrees)
7.
Apply the adhesive bond (B-10) at the two parts of the preset ring holder.
HELP16
It is done up that the point of lock spring is thin.
HELP17
Protector rubber is installed in fixed barrel.
Note:
Be careful not to damage A part of fixed barrel.
Apply the adhesive bond(B-10)
Apply the anti-diffusion agent(A-20)
Apply the adhesive bond(B-10)
Tape
Connect Barrel
Preset Ring
Steel Ball
Connect Barrel
Lock Spring
Fixed Barrel
Protector Rubber
A part
Click on the first or last page to see other SAL14TC service manuals if exist.