ILCE-QX1, ILCE-QX1L - Sony Digital Camera Service Manual (repair manual). Page 29

ILCE-QX1/QX1L

4-8

 OLPF

 

<Cleaning Procedure for the OLPF>
1. Clean up the tip of CCD cleaning jig.
2. Dab the tip of CCD cleaning jig at the OLPF, and pull 
    up straight.
    * Do not slide from right to left or up and down while 
      dabbing.
3. Repeat “3” several times to clean up.
4. According to the service manual, check if there is dirt 
   on the OLPF.

Cut

EE3310

If you cannot remove dirt with remedy above, cleaning by 

the following jig are used.

Soak a small amount of EE3310 (Liquid cleaner) after 

wrapping the cleaning cloth (J-6082-636-A) around the 

cleaning jig (J-6082-635-A).

CleaningCloth
(J-6082-636-A)

CleaningJig
(J-6082-635-A)

 
 

 

 

<Cleaning Procedure for Tip of CCD Cleaning Jig>
1. Put the two cleaning cloths on a tray like below.
 1

Souse the one cleaning cloth in ethyl alcohol. 

 2

Put the other cleaning cloth on a tray as it is dry.

2. Dab the tip of CCD cleaning jig at the cleaning cloth 
    of 1 5 or 6 times. 
     *Do not slide the tip from right to left or up and down 
      while dabbing.
3. Dab the tip of CCD cleaning jig at the cleaning cloth 
    of 2 5 or 6 times.
    *Do not slide from right to left or up and down while 
     dabbing.
4. Wait until the tip will be dried completely.  

2

 The dry cleaning cloth.

1

 Souse the cleaning

     cloth in ethyl alcohol.

<Preparation for Remedy>
If you use the new Jig (J-6082-663-A) below, make sure 
to clean the CCD Cleaning Jig (Tip) below before using, 
please.
Note: Protection sheet is for preventing the scratch of a 
          surface on the Jig (Tip). 
          The protection sheet may be come off the Jig 
          when you take the Jig from a bag, but it is no 
          problem.

Protection Sheet

CCD Cleaning
Jig (Tip)

CCD Cleaning 
Jig

CCD Cleaning Jig (New)
(J-6082-663-A)