Read Sony DSLR-A700P Service Manual online
2-1
SAL16105 (DT 3.5-5.6/16-105) (DT 16-105mm F3.5-5.6)
2. DISASSEMBLY
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
Notches
Holes
Universal wrench
J-6082-609-A
J-6082-609-A
Chip-A for
universal wrench:
J-6082-609-1
universal wrench:
J-6082-609-1
Chip-B for
universal wrench:
J-6082-609-2
universal wrench:
J-6082-609-2
Notches
Chip-A
Chip-A
Chip-B
Chip-B
Chip
Chip
Match the universal wrench
to the width of holes or notches.
to the width of holes or notches.
Universal wrench
Holes
A-20
B-110
B-40
G-118
O-20
B-10
G-115
G-116
LOCTITE 460
or the equivalent
or the equivalent
SERVICE TOOLS
Anti-diffusion agent (A-20):
J-6082-611-A
Adhesive bond (B-110):
J-6082-617-A
Adhesive bond (B-40):
J-6082-614-A
Grease (G-118):
J-6082-680-A
Oil (O-20):
J-6082-610-A
Adhesive bond (B-10):
J-6082-612-A
Grease (G-115):
J-6082-627-A
Grease (G-116):
J-6082-628-A
Adhesive bond (LOCTITE 460)
or the equivalent.
or the equivalent.
NOTE FOR REPAIR
• Make sure that the flat cable and flexible board are not cracked of bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, dont’ pull at wire of connector. It is possible that a wire is snapped.
• When installing a connector, dont’ press down at wire of connector.
It is possible that a wire is snapped.
• Do not apply excessive load to the gilded flexible board.
UNIVERSAL WRENCH
In case of the following notches or holes are located in the lens block, etc during disassembling/
assembling the lens, Use the universal wrench.
assembling the lens, Use the universal wrench.
How to Use
Attach the chip-A or chip-B to the universal wrench.
For the notches: chip-A
For the holes:
For the notches: chip-A
For the holes:
chip-B
Match the universal wrench to the holes or notches of the lens block, etc.
Click on the first or last page to see other DSLR-A700P service manuals if exist.