DSC-WX100 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 18

DSC-WX100_L2

1-15

Connector

Flexible Board

Claws

Sensors

OK

NG

FG Leaf

Spring

FG Leaf Spring

FG Leaf Spring

Claw

FPC Retainer

Flexible Board

FPC Tape

FPC Tape

Rib

Connector

17. Connect the two Flexible Boards to the Connectors on the LF-139 Flexible Board.
18. Stick the FPC Tape as shown in the figure below.

19. Install the two Sensors and attach the FG Leaf Spring.
      Note: Attach the FG Leaf Spring in the correct orientation.
20. Attach the FPC Retainer.

21. Apply a voltage of 2.5 V to the DC Motor and retract the Lens.

DC2.5V

Note: As for the figure below, this model and the shape

of the main body are different.

下図は当機種と本体の形状が異なります。

Inspect it as follows when you exchange parts in the lens block.

Zoom motion (Check five postures: horizontal, upward/downward, upper/lower oblique 45º)
No abnormal sound or motion must be found over full stroke between TELE end and WIDE end.
Zoom image
No abnormality such as a skipped image or wavy image must be found in the image through LCD or finder over full stroke between
TELE end and WIDE end.
Barrier (Check five postures: horizontal, upward/downward, upper/lower oblique 45º)
The barrier must be opened and closed fully, free from a sticking in the midway.
No abnormal sound must be heard during the operation.
Appearance condition Scratches or stains must not be noticeable, except that the customer permits them.
Foreign matters on the lens The lens condition must not be worse than that when the camera was received from the customer.

Lens at TELE end

Lens at WIDE end

Upward

Downward

Horizontal

Full stroke check

1

2

3

4

5

The changed portions from
Ver. 1.0 are shown in blue.