DSC-WX100 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 17

DSC-WX100_L2

1-14

3 Group Assy

Lever

Lever

1 Frame Assy

Cabinet Namber

Flexible Board

Claws

Main Body

Claws

Cam Tube A

Rotary Cam Tube

Semicircular 

Cutout

Gear Edge

Rotary Tube

Stationary Tube Assy

8. Install the Rotary Cam Tube to the Rotary Tube aligning the semicircular cutout with the Gear edge.
9. Install the Stationary Tube Assy at the position shown in the figure as a guideline.
    Note: Be sure to install the Rotary Cam Tube with the semicircular cutout and the Gear edge set in the "OK" state shown in the figure.

10. Install the Main Body so that the Flexible Board position matches the hole to pass the Flexible Board.

5. Install the 1 Frame Assy so the Lever positions match.
    Note: Confirm that the Barrier closes when the 1 Frame Assy is pushed.

6. Set the 3 Group Assy in the groove in the orientation where the Flexible Board comes to the nearly opposite side of the cabinet number 
    on the Cam Tube A.
    Note: Be sure to set the 3 Group Assy at the correct insertion position.

7. Push the 3 Group Assy until the three claws lock.

OK

NG

Fold inside

Draw up

Gear A

Gear A

Gear B

Gear Worm

Wheel

Rear Mirror

Plate

Z Retainer

Screws

Screw

Flexible Board

Sensor

LF-139 Flexible Board

Ribs

Rib

Rib

Rib

Boss

Boss

Boss

Boss

11. Turn the Gear in the arrow direction to extend the Mirror Plate slightly.
12. Turn portion A in the arrow direction to TELE end and remove the Flexible Board from the hole in the Stationary Tube Assy.

13. Install the Gear Worm Wheel, Gear A, and Gear B.
14. Install the Rear Mirror Plate.

15. Install four screws and the Z Retainer. Tighten the screws in the order of numbers in the figure below.

16. Install the LF-139 Flexible Board.

1

2

3

4