DSC-W830 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 15

DSC-W830

3-4

Usually, the camera has been set so as to disable the data writing from the PC to the internal memory of the camera.
This setting must be changed temporarily when the data is to be written to the internal memory such as a case after the board replacement.
To change settings is enabled with using the writing enabler tool (Write Enable Tool) on the Adjust Manual is activating from the Adjust Station.

1)  Start the Adjust Manual from the Adjust Station.

2) Click 

 (Write Enable Tool) button.

3)  Click “Activate Write Enable Mode” button.

4)  Upon completion of the setting change, the following message will be displayed.

5)  Return the driver to the original one, and connect the PC to the camera (USB mode: Mass Storage).
 

Perform the following procedure at the method order 5) when using [Write Enable Tool]. 

 

1.   Disconnect the USB cable from the camera.

 

2.   Reconnect the USB cable to the camera so that the camera is connected in  the Mass-Storage mode.

6)  Write the data read out into the PC to the internal memory of the camera.
7)  Disconnect the PC from the camera, and turn off the camera.

Note: By turning off the camera, the write enable setting is reset.

Use the battery (NP-BN) on repairing.
The external battery source cannot be used on repairing.

The changed portions from
Ver. 1.0 are shown in blue.