DSC-W830 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 13

Read Sony DSC-W830 (serv.man2) Service Manual online

DSC-W830
3-2
3-2.  NOTES FOR FLEXIBLE BOARD
Make sure that the conductive side of a flexible board does not have any stain or foreign materials.
Do not touch the conductive side of flexible boards with bare hands.
Plug in a flexible board straight, fully into the connector until it reaches the end inside. (Fig. 1, Fig. 2, Fig. 3)
OK 
(The flexible board was plugged in straight 
and completely)
NG 
(The flexible board was plugged in 
crooked.)
NG 
(The flexible board was not plugged in 
completely.)
Flexible
Board
Flexible
Board
Connector
Connector
Reference line
Flexible
Board
Connector
Connector
Flexible
Board
Reference line
Connector
Connector
Flexible
Board
Flexible
Board
Reference line
Fig. 1
Fig. 2
Fig. 3
When opening the connector's holder in direction A, do not open 
it with excessive force.
When closing the connector's holder, press it evenly while pushing 
a flexible board in direction B.
Holder
Connector
Flexible Board
A
A
Holder
Insulation side
Connector
Flexible Board
B
•  Make sure that the flat cable and flexible board are not cracked 
or bent at the contact end.
•  Do not apply excessive force to the gilded flexible board.
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
•  The proper way to disconnect a connector is to grab the con-
nector instead of the wires.  If you pull on the wires, they might 
be broken.
•  The proper way to connect a connector is to grab the connector 
instead of the wires.  If you push on the wires, they might be 
broken.
3-3.  DISCHARGING OF THE CHARGING CAPACITOR
The charging capacitor is charged up to the maximum 330 V potential.
There is a danger of electric shock by this high voltage when the capacitor is handled by hand. The electric shock is caused by the charged voltage 
which is kept without discharging when the main power of the unit is simply turned off. Therefore, the remaining voltage must be discharged.
Preparing the Short Jig
To preparing the short jig, a small clip is attached to each end of a resistor of 1 kΩ /1 W (1-215-869-11).
Wrap insulating tape fully around the leads of the resistor to prevent electrical shock.
Wrap insulating tape.
1 k
Ω/1 W
The changed portions from
Ver. 1.0 are shown in blue.
Ver. 1.1 2014.02
Page of 27
Display

Click on the first or last page to see other DSC-W830 (serv.man2) service manuals if exist.