Read Sony DSC-W580 (serv.man2) Service Manual online
DSC-W580_L2
2-2
NOTE FOR REPAIR
• Make sure that the flat cable and flexible board are not cracked of bent at
the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, don’t pull at wire of connector. It is possible that
a wire is snapped.
• When installing a connector, don’t press down at wire of connector.
It is possible that a wire is snapped.
It is possible that a wire is snapped.
• Do not apply excessive load to the gilded flexible board.
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
DISCHARGING OF THE CHARGING CAPACITOR (C901)
The charging capacitor is charged up to the maximum 315 V potential.
There is a danger of electric shock by this high voltage when the capacitor
is handled by hand. The electric shock is caused by the charged voltage
which is kept without discharging when the main power of the unit is
simply turned off. Therefore, the remaining voltage must be discharged
as described below.
There is a danger of electric shock by this high voltage when the capacitor
is handled by hand. The electric shock is caused by the charged voltage
which is kept without discharging when the main power of the unit is
simply turned off. Therefore, the remaining voltage must be discharged
as described below.
Preparing the Short Jig
To preparing the short jig, a small clip is attached to each end of a resistor
of 1 k
of 1 k
Ω /1 W (1-215-869-11).
Wrap insulating tape fully around the leads of the resistor to prevent elec-
trical shock.
trical shock.
1 k
Ω/1 W
Wrap insulating tape.
MA-472 Flexible
Board
Board
MA-472 Flexible
Board
Board
C901
R:1 k
Ω/1 W
C901
Note: High-voltage cautions
Discharging the Capacitor
Short-circuit between two points with
the short jig about 10 seconds.
Short-circuit between two points with
the short jig about 10 seconds.
(Part code: 1-215-869-11)
Click on the first or last page to see other DSC-W580 (serv.man2) service manuals if exist.