DSC-W380 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 4

DSC-W380_L2

1-1

When you replace to the repairing board, the written destination data of repairing board also might be changed to original setting.
Start the Adjust Manual in the Adjust Station and execute the “DESTINATON DATA WRITE”.

When you replace to the repairing board, get the data from the former one.
Start the Adjust Manual in the Adjust Station and perform “RESTORE DATA” to get the data. 
The data getting for this model is as follows.

• USB SERIAL No.
• Angular Velocity Sensor
• AWB standard data input & check, Color reproduction check
• Strobe adjustment

Note: When you cannot read data from the former replace the same time SY-262 board and lens.

PMB Portable has been written in internal memory.
SY-262 board for service is supplied with written the PMB Portable.

The set is shipped with a unique ID (USB Serial No.) written in it.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
Start the Adjust Manual in the Adjust Station and execute the “USB SERIAL No. INPUT”.

When you replace to the reparing board, write down the sensitivity displayed on the angular velocity sensor (SE401).
Start the Adjust Manual in the Adjust Station and execute the “Angular velocity sensor sensitivity adj”.

Note: The sensor sensitivity of SE401 of SY-262 board is written only repair parts.

When replacing the lens, write down the PITCH/YAW data given on the data sheet of the replacement lens for service.
Start the Adjust Manual in the Adjust Station and execute the “Angular velocity sensor sensitivity adj”.

Note: The PITCH/YAW data of lens are written only repair parts.

P.PP / Y.YY

PITCH/YAW data

YAW data

PITCH data

P.PP / Y.YY

SE401

PPP: PITCH sensor 

PPP

sensitivity

YYY: YAW sensor 

YYY

sensitivity

SY-262 BOARD (SIDE B)

The data can be copied/erased by the operations on the HOME screen. (When erasing the data, execute formatting the internal memory.)

Note 1:When replacing the SY-262 board, erase the data in internal memory of the board before replacement.
Note 2:When replacing the SY-262 board, execute formatting and initialize the internal memory after replacement.

Copies all images in the internal memory to a memory card.

1 Insert a memory card with sufficient free capacity into the camera.
2 MENU t  

(Settings) 

t  

(Memory 

Card 

Tool) 

t [Copy] t [OK] 

t z on the control button

• Use a fully charged battery pack. If you attempt to copy image files using a battery pack with little 

remaining charge, the battery pack may run out, causing copying to fail or possibly corrupting the data.

• Images cannot be copied individually.
• The original images in the internal memory are retained even after copying. To delete the contents of the 

internal memory, remove the memory card after copying, then format the internal memory ([Format] in 
[Internal Memory Tool]).

• A new folder is created on the memory card and all the data will be copied to it. You cannot choose a 

specific folder and copy images to it.

Formats the memory card or the internal memory. When you use a memory card with this 
camera for the first time, it is recommended to format the card using the camera for stable 
performance of the memory card before shooting. Note that formatting permanently erases all 
data on the memory card, and is unrecoverable. Save precious data on a computer, etc.

1 MENU t  

(Settings) 

t 

 (Memory Card Tool) or 

 (Internal 

Memory Tool) 

t [Format] t [OK] t z on the control button

• Note that formatting permanently erases all data including even protected images.