DSC-W30, DSC-W40 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 14

2-6

DSC-W30/W40_L2

Part Number

Part Name

Quantity

1

2-673-650-01

Ring (A), Ornamental

1

2

2-673-652-01

Barrier Assy

1

3

2-673-651-01

Tapping screw (B1.2

×4)

2

Torque driver
Soldering iron
Weight about 60g

Adhesive (Super X) (Note)

Use adhesive (Super X) or an equivalent article.
Don’t use what becomes white after drying like a quick-drying glue.

The Ornamental Ring A has adhered to the Barrier Assy strongly and accordingly, use a soldering iron to weaken the adhesive force.
Heat four circled portions with the soldering iron.
Heating temperature is about 300ºC.
Beware of a burn since the entire Ornamental Ring becomes hot.
*

As the adhesive force of Ornamental Ring A is considerably large, the forced peeling will damage the group-1 frame.

Insert the tip of tweezers, etc. into a notch of the group-1 frame and prize the ring.
*

Take extreme care so as not to damage the coated surface of the group-1 frame.

In case of difficult peeling, heat the ring again with the soldering iron.
If this re-heating failed, it may be advisable that the ring be peeled while heating the portions 1 

→ 2 in the under figure one by one

sequentially.

*

Discard the removed Ornamental Ring A.

1

2

3

Tip

1

2

The changed portions from
Ver. 1.5 are shown in blue.