DSC-TX30 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 38

DSC-TX30_L2

3-2E

Assembly-1: Caution for Handling the Lens Device and other 

parts of the Lens Block

Hold the Lens Block as shown figure.

CD-829 Board

Sensor

Motor

Lens

  Very weak

  Very weak

  Very weak

  Very weak

Motor

  Very weak

Do not hold the following parts.

PRECAUTIONS WHEN HOLDING THE LENS BLOCK

• IR cut coating surface
  The red coating is reflected.

• The other surface
  The red coating is 
  not reflected.

• Side view
  The red belt
  is seen.

Lens Device side

Lens Device side

Hold it with tweezers or the like.

Optical Filter  Block 

The one side of the Optical Filter Block has treated

How to distinguish the side of Optical Filter Block
facing to Lens Device.

with IR cut coating.
Mount the Optical Filter Block  facing the IR cut 
coated side to the lens device.
Distinguish the IR cut coated side from the other by
applying the fluorescent light to 
the Optical Filter Block in the dark place
(cut off the outside light).

G12 Protection Sheet is supplied with the LSV-1501A
(SERVICE). This part is used to protect the LSV-1501A (SERVICE).
Remove this part when replacing the LSV-1501A (SERVICE).
And install the G10 Seal (1500).

Install the G10 Seal (1500)

Remove the G12 Protection Seal

LSV-1501A (Service)

Assembly-2: Notes on Assembling the MIC Rubber

Install the MIC Rubber to the RL-1005 Flexible Board
as shown in the figure.

RL-1005 Flexible
Board

RL-1005 Flexible
Board

MIC Rubbers

MIC Rubbers

Assembly-3: Notes on Assembling the RL-1005 Flexible Board

Boss

Bosses

RL-1005 Flexible Board