Read Sony DSC-TX30 (serv.man2) Service Manual online
DSC-TX30_L2
3-1
3. ASSEMBLY
Releasing Claws of the Cabinet (Front) Block Assy
(1) Insert the jig while lifting portion A in the direction of
arrow to release claw
arrow to release claw
1
.
(3) Insert the jig into claw
5
to release it.
(5) Open the cabinet (front) block assy in the direction
of arrow and release three claws (
of arrow and release three claws (
7
,
8
,
9
) on the
side panel to remove the cabinet (front) block assy.
(2) Insert the jig into claws
2
,
3
, and
4
to release claw
2
first, claw
3
, and then claw
4
sequentially.
Claw 1
Jig
Claw 2
Claw 3
Claw 4
Claw 7
Claw 8
Claw 9
Claw 5
Be sure to use a jig to release the claws of the cabinet (front)
block assy paying attention not to damage them.
block assy paying attention not to damage them.
Portion A
J-6082-771-A
CABINET REMOVER
CABINET REMOVER
(4) Insert the jig into claw
6
to release it.
Claw 6
Notes on Disconnecting and Connecting the TP Flexible Board
Prohibited Work
NG
NG
OK
OK
Recommended Work
Hold the ends of the TP flexible board with tweezers, bend it
up 90 degrees, and then insert it horizontally.
up 90 degrees, and then insert it horizontally.
Hold the reinforcing plate with tweezers and insert it in the
obliquely upward direction.
obliquely upward direction.
Push the ears of the flexible board reinforcing plate with
tweezers to disconnect it.
tweezers to disconnect it.
If the TP flexible board is not inserted
properly, push the ears of the
reinforcing plate with tweezers.
properly, push the ears of the
reinforcing plate with tweezers.
Hold the ends of the TP flexible board with tweezers and
pull it out horizontally.
pull it out horizontally.
TP flexible board
TP flexible board
SY-1009 Board
Connector
Reinforcing
plate
plate
TP flexible board
SY-1009 Board
Connector
Reinforcing
plate
plate
Tweezers
TP flexible board
SY-1009 Board
Connector
Reinforcing
plate
plate
Tweezers
TP flexible board
Click on the first or last page to see other DSC-TX30 (serv.man2) service manuals if exist.