DSC-TX10 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 10

DSC-TX10_L2

1-7

Note: If the TP adhesive sheet is not removed after alcohol or ethanol was applied to the location specified in step 2, also apply it to the locations shown in the figure 

below.

 

3.  Insert a precision flat-blade screwdriver to generate a gap.
 

Apply alcohol or ethanol to the tip of the screwdriver.

 

Insert the screwdriver into the gap between the LCD assy and the rear cabinet assy and move the screwdriver slowly to detach the LCD assy.

 

Detach the LCD assy while removing the adhering TP adhesive sheet.

 

Note: The TP adhesive sheet is attached to the location shown in the figure below.
 

Do not insert a precision flat-blade screwdriver or the like beyond this location.

 

If it is inserted into inside the location, it may damage the LCD assy.

 

TP Adhesive Sheet

4.  Remove the TP adhesive sheet completely to clear the adhesion of the sheet.
 

Do not left the adhesive material.

1.  Remove the two fixed screws of BTL Packing.

 

2.  Remove the packing, and confirm that there is no scratch such as defect on the BTL Cover or BTL Packing Fixed Plate.

 

3.  Install the new BTL Packing. (also use the new screws)

Note: Be careful that there is no dust on the packing.

Note: The LCD assy and the rear cabinet assy are fixed with double-sided adhesive tape.
 

Disassemble and assemble them according to the instructions.

1.  Remove the ornamental rear cabinet.
2.  To remove TP adhesive sheet (double-sided adhesive tape), apply alcohol or ethanol to the location shown in the figure.
 

Insert a precision flat-blade screwdriver (0.2 mm tip) or a spatula between the LCD assy and the rear cabinet assy, and apply alcohol or ethanol.

2mm

LCD

Cross-section

Touch Panel Glass

Cabinet (Rear) Assy

TP Adhesive Sheet
(Double-sided

adhesive tape)