Read Sony DSC-T500 (serv.man3) Service Manual online
6-4
DSC-T500_ADJ
2) As shown below, connect the lead wires attached with alligator clips to the check land and GND of the board so as to enable a short circuit
or open circuit to the GND.
Fig. 6-1-3
1-3-2. How to Enter Adjustment Mode
1) Connect the set to the modified multi-output stand.
2) Connect the PC and the modified multi-output stand.
3) Turn on the power with the lead wires connected to the GND of the board (Adjustment mode ON state) as mentioned in “1-3-1. Multi-
2) Connect the PC and the modified multi-output stand.
3) Turn on the power with the lead wires connected to the GND of the board (Adjustment mode ON state) as mentioned in “1-3-1. Multi-
Output Stand Modification Procedure”.
4) Change the USB driver to the one for SeusZ.
Note:
The set has been so designed that the power is turned off automatically in about 60 seconds after the power was turned on.
If the power is turned off automatically while the USB driver is changing, turn on the power again and retry.
If the power is turned off automatically while the USB driver is changing, turn on the power again and retry.
1
45
48
50
47
49
19
1
23
21
20
22
CN001
CN003
CL001
CL002
CL003
2
46
7
6
5
1
CN002
C001
C002
LF001
J001
J002
FB001
VDR001
FB002
VDR002
VDR003
FB003
VDR004
VDR005
FB006
R001
1
4
32
1
5
3
4
Short circuit: Adjustment mode ON state
Open circuit: Adjustment mode OFF state
HDMI OUT
A/V OUT
(STEREO)
USB
DC IN
from the Conductor side
from the Component side
Click on the first or last page to see other DSC-T500 (serv.man3) service manuals if exist.