Read Sony DSC-S3000 (serv.man3) Service Manual online
Sony Corporation
DSC-S3000_L2
LEVEL
2
9-834-561-81
SUPPLEMENT-1
File this supplement with the service manual.
• Change of REPAIR PARTS LIST
• Addition of SERVICE NOTE
• Addition of REPAIR PARTS LIST
• Addition of SERVICE NOTE
• Addition of REPAIR PARTS LIST
(12-197)
SERVICE MANUAL
Ver. 1.1 2012.08
2012H08-1
© 2012.08
Published by Sony Techno Create Corporation
2. REPAIR PARTS LIST
2-1. EXPLODED VIEWS
-
: Points changed portion
Page
Former
New
2-5
2-1-3. MAIN BOARD SECTION
1
108
(Note3)
ns
2-1-3. MAIN BOARD SECTION
1
108
(Note3)
ns
(Lens Block Section
(See page 14 (Supplement-1))
)
Some parts included in the lens unit used in this model have been added as independent replacement parts.
When replacing such parts, perform disassembling and reassembling according to SERVICE NOTE.
When replacing such parts, perform disassembling and reassembling according to SERVICE NOTE.
Note:
This manual includes additional service parts.
When additional service parts are replaced, adjustments are required.
For details, refer to “REPAIR PARTS LIST (LENS BLOCK SECTION)” on page 14 of this manual.
Canadian Model
AEP Model
E Model
Australian Model
Korea Model
Brazilian Model
DSC-S3000
– 2 –
DSC-S3000_L2
SERVICE NOTE
MOTOR UNIT REPLACING METHOD
Removal / Installation
(1) Disconnect the soldered connection.
(2) Remove the four screws. (4-277-820-01)
(3) Remove the REAR RETAINER.
REAR RETAINER
2ND FOCUS GEAR
ZOOM LONG GEAR
(4) Remove the 2ND FOCUS GEAR and the ZOOM LONG GEAR.
(5) Remove the PI part with a tool such as flat-blade screwdriver.
(6) Release the hooked FPC, and remove the other PI part with a tool such as flat-blade screwdriver.
PI part
Flat-blade screwdriver
Flat-blade screwdriver
Hooked FPC
– 3 –
DSC-S3000_L2
(7) Remove the screw fastening the focus motor part.
(8) Remove the two screws fastening the zoom drive part.
(9) MOTOR UNIT can be removed.
(10) After the MOTOR UNIT has been replaced with a new one, return the process from (9) to (1) according
to the process flow.
BARRIER ASSY REPLACING METHOD
Removal
(1) Heat the COSMETIC RING with a heater such as hair dryer.
Pour solvent such as ethyl alcohol.
Pick the COSMETIC RING with a thin tool such as cutter knife.
Pick the COSMETIC RING with a thin tool such as cutter knife.
(2) After removing the COSMETIC RING ASSY:
Outside
Inside
– 4 –
DSC-S3000_L2
Locked hook
Unlocked hook
Outside
Inside
(3) Unlock the two hooks with tweezers.
(4) Remove the BARRIER ASSY.
(5) The BARRIER ASSY can be removed.
Installation
(1) Align the lever with the lever hole as shown in the figure.
(2) Insert the BARRIER ASSY.
(3) Turn the BARRIER ASSY in the arrow direction (clockwise) with tweezers so that the two hooks are locked.
Hole
Lever
